Universal Wireless Remote Control Switch Electric Socket EU France control plug Programmable Electrical Outlet | Электроника

Universal Wireless Remote Control Switch Electric Socket EU France control plug Programmable Electrical Outlet | Электроника

3.28 promotion: please use the discount code according to different countries.

Universal Wireless Remote Control Switch Electric Socket EU France Remote control plug Programmable Electrical Outlet Switch

Features:
◆The socket can be manually operated or via the Remote Control.
◆The night light can only be controlled by the transmitter.
◆The socket receiver will still remain in the “OFF” mode after power out, even when the power comes on again.
◆ The transmitter and the socket receiver can be freely combined ( transmitter or socket receiver must from our company), only need to program according to the manual.
◆1 remote control can control 5 sockets, which can be combined freely.
◆Super strong RF signal, can penetrate the wall.
◆Socket power supply and night light can be used separately.

socket receiver
Input Voltage: 230V AC,50/60Hz
Max.load current: 16A
Transmission frequency: 433MHz

transmitter
Power for transmitter:
1 section DC12V 23A battery
(make sure the installation of battery is correct,Product does not include battery)

All remote controlled sockets have been pre-programmed and can be used immediately.

To re-program the remote control transmitter and socket receiver, please follow instructions below.
Detailed Self- Learning Operation:

Re-programming
■Plug the remote controlled socket to a power point and turn the power on.
■Press and hold the power button of the socket receiver for about 3 seconds till the LED indicator on.
■Release the power button.
■Click the left button of the transmitter.Socket programming successful when the LED indicator flashes until it stays on.
■Continue click the right button of the transmitter.Night light programming successful when the LED indicator flashes until it stays on.
（Note: The programming interval of the left and right buttons must be less than 8 seconds, otherwise the night light fail to be programmed.）
■ The remote controlled socket is now ready to use.

Clear programming
■Plug the remote controlled socket to a power point and turn the power on.
■Press and hold the power button of the socket receiver for about 8 seconds until the LED indicator flashes to go off.
■Release the power button.The clear programming is successful.