3S 4A 11.1V lipo lithium Polymer BMS/PCM/PCB battery protection circuit board for 3 Pack 18650 Li-ion Battery Cell | Электронные

3S 4A 11.1V lipo lithium Polymer BMS/PCM/PCB battery protection circuit board for 3 Pack 18650 Li-ion Battery Cell | Электронные

Features:

1) high-accuracy voltage detection circuit;

2) terminal of the charger using high voltage device;

3) Built-in three-stage over-current detection circuit (over-current 1, over-current 2, or load short circuit);

4) MOS transistor can control the battery charge and discharge;

5) low standby current consumption.

3S Li-ion BMS Parameters:

3S BMS Cnnection instruction:

B+    Connect battery positive;

B-    Connect battery negative;

10.8V  Connect the point between battery1 & battery 2;

7.2V  Connect the point between battery 2 and battery 3 

3.6V  Without connection

B-    Battery negative end

P+    Charge/discharge positive; 

P-     Charge/discharge negative

Aplications:

3S li-ion18650, licoo2, limn2o4, Li (nicomn) O2 baterías recargables

3S lipo baterías recargables

Notice:

1) Please note that the input and output voltage, and load current conditions for power protection board does not exceed the electrical parameters of the allowable power consumption;

2) special attention to the load current can not work long hours between maximum continuous operating current and over-current protection current;

3) When connecting the battery ,it may not discharge. In this case, connect the charger can be restored to normal working condition;

4) Although the BMS built-in electrostatic protection circuit, but please do not hand touch  when BMS in the working condition, so as to avoid damage from static electricity protection board.

​