0 5 в 4 20 мА 485 Тип Датчик скорости ветра/выходное напряжение анемометр/360 градусов

0 5 в 4 20 мА 485 Тип Датчик скорости ветра/выходное напряжение анемометр/360 градусов

 Wind 0-5V/4-20ma RS485 Type Wind Speed Sensor/Voltage Output Anemometer/360 Degree

Important NOTE before you order,

For the output, we have SIX KINDS,

1: current type 4~20mA

2: voltage type  0.4~2V

3: pulse output

4: voltage type 0~5V

5: voltage type 1~5V

6: 485 type

We'll send current type 4~20mA in default if you don't remark=) Thank you for your cooperation~

Applicable Scope

♦Working aloft testing and control

♦Engineering machine testing and control

♦Weather station and environment protection testing and control

♦Port and wharf environment testing and control

♦Other industrial automation about wind speed and direction testing and control 

Specification

♦ Accuracy: ± 1m / s 

♦ Start wind speed: 0.2-0.4m / s 

♦ Voltage output type: 

 Range: 0 ~ 32.4m / s  

 Supply voltage: 7V ~ 24VDC 

Output signals: 0.4 ~ 2V  or 0~5 V , 1~5 V

 Wind speed values = ( output voltage -0.4) /1.6*32.4 

♦ Current output type: 

 Range: 0 ~ 32.4m / s 

 Supply voltage: 12V ~ 24VDC 

 Output signal: 4 ~ 20mA 

 Load capacity: = ≤200 ohms 

 Wind speed values = ( output  current -0.4) /1.6*32.4 

 ♦ Pulse output type: 

 Range: 0 ~ 60M / S 

 Output signal: pulse (each pulse corresponds to 0.88m / s) 

 Supply voltage: 5V ~ 24VDC 

Dimension

Installation

♦The sensor is installed horizontally as shown in the figure, and the angle between the mounting base and the horizontal plane should not exceed 5° so as to ensure that the wind speed can be measured accurately by the sensor under low wind speed conditions.

♦The positions and shapes of the wind cup and the windmill arm can directly affect the accuracy of the sensor as shown in the above figure. Do not hold the wind cup and the windmill arm during installation, so as to avoid the damage to the sensor structure and the influence on the accuracy of measurement.

Real Pictures Shows

ca