2019 Solar Charge Controller 12V 24V LCD Display Autoswitch Charger Regulator + 5 Pairs M/F Cable Connectors | Обустройство дома

2019 Solar Charge Controller 12V 24V LCD Display Autoswitch Charger Regulator + 5 Pairs M/F Cable Connectors | Обустройство дома

Item description
1. over-load protection                   
2. short circuit protection                                        
3. protection from the lightning strike
4. under-voltage protection                 
5. over-charging protection
6. reverse polarity protection
The charge indicator: While charging, the charge indicator will be green light ON. When the battery indicator is flashing uninterruptedly, it means the battery is full charge and the system enters into intelligent protective charging.

Battery voltage display screen: the battery voltage will display only when the battery power is normal.

Battery under voltage display: when the battery is in the state of under voltage , (in the 12V system the battery voltage is less than 12V, in the 24V system the battery voltage is less than20V), a middle cross of the digital tube flickers as is shows in the figure.

Installation Instructions:
Open the top cover of controller and connect the wire with terminals as the diagram on the top cover of it.
1.Connect the "+","-" poles of the battery to the corresponding ports of controller (the third and the fourth one from left).
2.Connect the "+","-" poles of the solar pannel to the corresponding ports of controller (the first and the second one from left).
3.Connect the "+","-" poles of the load to the corresponding ports of controller (the fifth and the sixth one from left).
Note: If there is connection error, it may damage your controller.

Parameters:
Rated charge current: 10A 
Rated discharge current: 10A
Over load, short circuit protection: 1.5 times by the rated current
Short circuit recovery time: 10s
Open circuit voltage of solar panel: 55V 
No load loss: 0.05W
Over voltage protection: 15V,24V
Float charge voltage: 14V,24V
Discharge recovery voltage:12V,24V
Over discharge voltage: 10.5V,24V
Control mode: software intelligent control
Working temperature:  -35 ~ +55°C
Dimension  (L*W*H)95.1 x 102.5 x 38.5(mm)

Specification of Connector:
Rated current: 25A (2.5-4.0mm2)
Degree of protection: IP2 * / IP67
Rated voltage: 1000V DC
Flammability rating: UL94-V0
Test voltage: 6000V (50Hz, 1min)
Safety: II
Overvoltage category / Pollution Index: CATIII / 2
Adapter Wire: OD4.5-7.0 (2.5-4.0mm2)
Connector contact resistance: 0.5mΩ
Insertion / Extraction Force: ≤ 50N / ≥ 50N
Connector conductor material: copper, tin
Connection: Crimp
Connector Insulation material: PPO or PBT
Operating temperature range: -40 ~ +90 ℃

Package Includes:
1x Solar charge controller
1x English User manual
5 x male solar panel cable connector
5 x female solar panel cable connector

(Retail package is NOT included)