Car Window Glass Repair Fluid Kit Windshield DIY Scratch Crack Restore Tool Easy To Use - Takes Only Minutes | Автомобили и

Car Window Glass Repair Fluid Kit Windshield DIY Scratch Crack Restore Tool Easy To Use - Takes Only Minutes | Автомобили и

Item Details:

*100% Brand new and high quality
*Easy to Operate:Allow you to make permanent air-tight repairs on most laminated windshield glass. such as repair small cracks, cobwebs, star damage , combination damage and so on only in 20 minutes

*Easy to use - takes only minutes
*Repairs all types of laminated windshields
*Practical and long-lasting,no dicoloration
*Does not yellow after repairing
*Good for multiple repairs

Specification:

*Product Name:Auto Glass Repair Tool
*Product material:ABS silicone
*Suitable for:universal

Using Steps:

1. Clean the periphery of the broken glass. The old wound can be cleaned with cotton swab droplet repair solution. There can be no residual moisture and stains.
2. Find port at the damaged place and remove the broken glass with a pick-up needle.
3. Cut the long solidified film according to its broken length (width is not cut to ensure that cracks can be completely covered)
4. Point the repair fluid along the crack breakage, then cover it quickly with the curing film, place the crack in the middle of the curing film and cover it completely.
5. All the between the glass and the curing film are extruded. The whole curing film is completely adhered to the glass by the repairing liquid. The whole repairing process should keep the curing film immovable and free from air.
6. Drop a drop of liquid on the suction cup, and then press it hard in the middle of the crack to keep for 1 minute, so that the suction cup and the curing film are joined [the suction cup is preferably located at the crack break].
7. Pull the suction cup up with your index finger [pay attention not to pull it off], and keep the exhaust for more than 2-3 minutes.
8. During this period, bubble will continue to out. Once the bubble are extruded from the curing film, the agent bubble will continue to be pulled.
9. Be patient to change position and pull it up several times until there are no cracks in which there are no black dots and cracks fade away slowly.
The cracks were observed at an angle of 10.45 degrees and disappeared after the black dots moved rapidly toward the sucker lifting position.
11. With a pen, align the crack in the car towards the crack in the middle of the crack to the top of the crack (please pay attention to it moderately), the black dots in the crack will be further , the liquid permeation will intensify, and the crack will be further desalinated and disappeared.
The glass was observed at an angle of 12.45 degrees until the crack disappeared and then cured, once cured, it could not be repaired again.
13. Keep the curing film covered by the crack and move to the sun for 10-30 minutes or use ultraviolet lamp instead of curing until curing.
14. Tear off the curing film and scrape the redundant resin to repair the end.
Be careful:
The air is not exhausted and the permeation is not ideal. Never solidify in advance. Once solidified, it can not be repaired again.
If there is residual fog, drop as little repair liquid as possible in the fog, cover the curing film and naturally adhere, never touch with anything. After ultraviolet curing, tear off the curing film and do not scrape with a razor blade. 

Package Contents:

4 * Suckers
1 * Repair Fluid
1 * Pick Needle
1 * Repair Blade
1* Cured Film

Notes: 

1. The real color of the item may be slightly different from the pictures shown on website caused by many factors such as brightness of your monitor and light brightness.
2. Please allow slight manual measurement deviation for the data.